Measuring your penis is one of many things that can make or break a successful penis enlargement. One could almost compare it with a good show on television.

Wrong Approach of Penis Measurement

If it is scheduled too often it loses the precious rarity value, if it is once a month without reruns people lose interest and move on to something new.

None of these approaches is desirable and wisdom penis enlargement customer soon learns not to take the ruler too often and also learns to keep his own interest focused on the enlargement process without the frequent need for the measure.

1. The biggest problem is that often the extent of may destroy the purpose and will continue. The penis needs time to respond to enlargement and the measurement technique is often unlikely to show significant gains. It takes a number of weeks to add an inch to the penis, a weekly measure is not a good idea.
2. Measuring invalid. Measuring the penis is always a little more difficult and an experienced customer needs to know all the tricks in order to have a clear idea about the effect of the expanded efforts on the penis itself.
3. The basic rule to correct the measure of consistency. You need to put an end to the ruler in the same place over and over again to see the exact amount of length and girth gained by your penis. That is why the measurement technique is to use known as the "bone pressed flaccid / erect length." The reason why it is so called because the ruler is put on the side of the penis and a little pressed in the pubic bone.

The bone is used to provide fixed place we discussed, irrespective of factors influencing May penis size. As you probably know already, the penis is sensitive mass of fabric through which much blood is circulated. It shrinks cold and it widens a little heat. Hold tight pants down while jogging in the morning is likely to engorge as it puts the entire cardiovascular system in motion.

That's why you should measure your length of the bone and not the fat that covers pad. In fact, you can use both measurement techniques and put both results in your logbook. This way you know how long your penis really is and how it can be seen above the carpet fat. However, you must keep in mind that any layer of fat added to the platform will reduce in the penis size and make it look smaller.

This means that sometimes lost a little weight can make the difference between a successful penis enlargement program and a total failure. It does not really matter if your penis added a quarter of an inch in a month, if you're fat pad has a half-inch. But using measurement techniques at the same time could point to where you the real problem lies. 

The Coorect Way to Measure of Penis

Here's the way how to measure your penis correctly:

The Length measurement

• Flaccid state (soft)

1. Use a ruler, measure from from the side of the penis, with the ruler facing up at you.
2. While standing, extend your flaccid penis outward with one hand so that your penis is parallel to the floor.
3. Use your other hand to hold the ruler next to your penis pressed against your area just above the base of the penis. Make sure your penis and the ruler are parallel with one another.
4. Measure to the tip of the head and record your measurement to the nearest millimeter.

• Fully erect state (hard)

1. Just the same at #1 above
2. While standing, lock your knees and hold your penis with one hand just behind the head. Gently angle your erect penis until it's parallel to the floor.
3. Repeat the step #3 above.
4. Gently pull your penis out as far as you can and measure to the tip of the head and record your measurement to the nearest millimeter.

The Girth (diameter) measurement

• Fully erect state (hard) and Flaccid state (soft)

1. Use a cloth measuring tape.
2. At different part of the shaft, your penis may vary in girth, so it is necessary to pick one spot and continue to measure at that point only in the next measurement. This will help to ensure the most accurate measurement comparisons.Record your measurement to the nearest millimeter.
3. Notes: you want to pick the average width, not the widest or the slimmest part of the penis. Suggested that you choose the midpoint on the penis as your average.