| STEPS |
DESCRIPTION |
NOTES |
| Step #1 |
Soak a soft and adsorbent hand-towel in warm water, then extract by squeezing any excess water;
Try by touching it the towel around your
penis to make sure that it’s a temperature appropriate;
|
Step # 1 to #3 are warming-up steps. This is important
because it helps to make blood stream to the penis. The slightly wet heat also
make the penis’s skin more soft, which shall ensure a better grip for upcoming
wearing traction device.
Sometimes when remove the towel then your penis
may look of a light shade of red due to the increased flow of blood. Don’t worry, this is a normal situation. Some men have a higher tolerance for heat, so the penis may not look any different. |
| Step #2 |
In
flaccid or erect condition, cover entire your penis (including the head) by
towel; hold the towel in the position for about 3 to 5 minutes; then remove the
towel; |
| Step #3 |
Make
dry your penis with another one towel; |
| Step #4 |
Make
your penis in semi-erect state (1/2 or 3/4 erect); |
Wear the device from 2 to 8 hours a day (depending on your preference).
It is not advised to wear the device more than
8 hours a day (you must give your penis a chance to recover and rebuild
tissues, effectively enlarging itself day by day). |
| Step #5 |
Open
the silicone loop (ring) then enter over head to the base of your penis base of through
the plastic SizeGenetics™ device;
|
| Step #6 |
Strap the soft SizeGenetics™ comfort pad into the device; |
| Step #7 |
Now
pull the loop down carefully until the head is secure; |
| Step #8 |
Finally,
do a little adjustment of the device to the penis for your comfortable. |
